- How to upgrade your MacBook Pro with an SSD
- MacBook Pro 15" Unibody Mid 2009 Hard Drive Replacement
- MacBook Pro 13" Unibody Mid 2009 SSD Installation
How to upgrade your MacBook Pro with an SSD
How to get ready, install, and set up a new Hard Drive in your Macbook Pro / Transfer infoand
Featured Guide. Time Required. Buy these tools. Buy these parts. Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.
Thank you. What type of hard drive do these models support? How do you replace the hard drive with an SSD? Upgrading the hard drive in the "Mid," "Mid," "Early ," "Late " and non-Retina Display "Mid" MacBook Pro models requires a screwdriver, but it still is a simple and straightforward procedure. If a hard drive was installed by default, it is quite possible to replace the stock hard drive with an SSD, too. Photo Credit: Apple, Inc. If you're not sure which "Unibody" MacBook Pro model you have, many of these systems share Model Numbers , unfortunately.
Time Required. When replacing your hard drive, you must transfer the four locating pins removed with a T6 screwdriver from the old hard drive to the new one. Some drive bays have a height of 7 mm, while others have a height of 9. Depending on the size of your drive bay, you may need to use a spacer to make your SSD fit properly. Remove the following 10 screws securing the lower case to the MacBook Pro 13" Unibody:.
To start the conversation again, simply ask a new question. Posted on May 23, AM. May 23, AM in response to buddhahat In response to buddhahat. OWC is, of course, just an option. They make it "easy" to do a drive replacement with their kits. Since your can still boot up your Mac from the original HD, the basic steps to replace it would be:.
MacBook Pro 15" Unibody Mid 2009 Hard Drive Replacement
If you have an old MacBook Pro with one foot in the grave, the single best thing you can do to breathe new life into it is replace its traditional spinning hard drive with a solid-state drive. They are more energy efficient, more reliable and quieter than hard drives with magnetic, spinning disks., Time Required. When replacing your hard drive, you must transfer the four locating pins removed with a T6 screwdriver from the old hard drive to the new one.
MacBook Pro 13" Unibody Mid 2009 SSD Installation
To start the conversation again, simply ask a new question. Ive had a diagnostics run on my mid MacBook Pro 13" 2. Is it a job I should be getting a pro to do as it sounds pretty complicated and would like to just take it in and pick it if you know what I mean but I dont want to spend over the odds. Posted on Feb 19, PM. Page content loaded.
MacBook (late 2009): Hard Disk Drive (HDD) vs Solid-state Drive (SSD)
Replace the hard drive in your MacBook Pro 13" Unibody Mid
why do muslims hate dogs